Programming Micro800 PLCs with Connected Components Workbench
Description
AB-CCW-PLC-120 teaches you how to enhance your Connected Components Workbench projects using extended bit instructions.
In this course, you will learn;
How to use Set Coil and Reset Coil instructions,
How to use One-Shot instructions like R_TRIG,
How to program and test error latching logic,
How to program and test toggle buttons
Contents
Introduction
This section introduces the course content and the project that you will be testing
Open the Project
This section explains how to set up the base project that we will use in this course
Work with Set Coil and Reset Coil Instructions
This section introduces you to Set Coil and Reset Coil instructions and explains how you can use these instructions to program latching logic
Work with One-Shot Instructions
This section introduces you to One-Shot instructions, explains what type of One-Shot instructions are available in Connected Components Workbench and explains how One-Shot instructions can be used to program a toggle button
Test the Project
This section explains how to test the project that we have built in this course using the Micro800 Simulator
Course Conclusion
This section recaps what you have learned on this course and outlines the next steps that you can take on your journey as an automation professional
